Bürkert - Close to you
Office /2
    • Main Office
      Burkert Middle East FZE
      Ras al Khaimah | United Arab Emirates

      Phone +971 7207 6696
      Fax +971 7207 6695
      E-Mail fnyrf.nr@ohexreg.pbz
    • Distributor
      Daly Fluid Technologies LLC – DFT
      Dubai | United Arab Emirates
      Phone +971 4887 8185
      Fax +971 4887 8184
      E-Mail fnyrf@qsgzr.pbz
  • Main Office
  • Headquarters
  • Systemhaus
  • Distributor
  • Office
  • Plant
  • Logistic center
bürkert
We make ideas flow.
We make ideas flow.

    2/2 way Solenoid Valve Servo Operated for High Pressure

    Type 2400 / Ident No. 422

    Produkt-Foto Typ 2400

    The depiction of the products may differ from the actual specific design.

    • Produkt-Foto Typ 2400
    • Massbild
    • Massbild
    • Massbild
    • SPD-2400-NR-51_thumb.png

    2/2-way high pressure solenoid valve

    • Push-over solenoid system
    • Special versions, up to 250 bar, up to DN 12
    • stainless steel body

    For selecting the correct product please refer to the technical data, images and notes for proper use according to the data sheet.

    Product description

    The servo-assisted Type 2400 valve has aservo-piston with a 2-way servo-control. It is designed for high pressures. The speciality of this valve design lies in the layout of the seat and sealing element. Anadditional radial seal make very good sealing possible. The tapered sealing element of the servocontrol permits the switching of high pressureat relatively low coil power.


    Commodity Codes
    84818073
    Country
    DE

    Technical attributes

    Name
    Value
    Unit
    Type 2400
    Operation servo-controlled
    Actuator type Plunger valve
    Main valve operating principle Globe valve
    Switch function on/off
    Media separation No
    Valve function A - normally inlet port 1 (P/NC) closed
    Fluidic port connection number 2 PCE
    Valve function number of switching positions 2 PCE
    Valve function manual actuation No
    Flow Above seat
    Nominal pressure min 1 bar
    Nominal pressure max (liquid) 250 bar
    Main valve orifice 1 (P) (mm) 12 mm
    Kv value (water) 2.6 m3/h
    QNn value (gas) 2800 l/min
    Main valve wetted material Stainless steel
    Port connection 1 type Inner thread
    Port connection 1 thread type G
    Port connection 1 thread marking 1/2
    Port connection 2 type Inner thread
    Port connection 2 thread type G
    Port connection 2 thread marking 1/2
    Valve seat material Stainless steel
    Medium-contacting part core material Stainless steel
    Medium-contacting part stopper material Stainless steel
    Seat seal material PCTFE (Polychlorotrifluoroethylene)
    Sealing toward outside material FKM (Fluor rubber)
    Temperature environment max 55 °C
    Temperature medium min -10 °C
    Temperature medium max 100 °C
    Voltage / rated voltage 230 V
    Voltage / rated voltage 230 V
    Voltage tolerance negative 10 %
    Voltage tolerance positive 10 %
    Voltage frequency 50 Hz
    AC voltage Yes
    DC voltage No
    Battery voltage No
    Rated power consumption 20 W
    inrush power consumption AC 85 V·A
    Rated power AC 48 V·A
    Electrical connection sort Plug pattern form A according to DIN EN 175301-803
    Electrical connection number of contacts 2 + Grounding conductor
    Electrical connection position in direction of flow left
    Protection type (IP max. with suitable connector) 65
    Coil type placed on top
    Coil insulation material (encasement) Epoxy
    Coil wiring overvoltage protection without
    Coil wiring rectifier No
    Coil wiring polarity recovery diode No
    Thermal insulation class of the actuator H
    Nominal operation/Duty cycle 100 %
    Switch time open min 100 ms
    Switch time open max. 200 ms
    Switch time close min 300 ms
    Switch time close max. 500 ms
    Valve setting opening time No
    Valve setting closing time No
    Back-pressure-resistant version No
    Vacuum version No
    Analysis version No
    Oxygen version No
    Oil burner valve No
    Steam version No
    Pilot control seal material PCTFE (Polychlortrifluorethylene)
    Low-noise version No
    Main valve with integrated screen No
    Installation length 75 mm
    Without mounting No
    Valve construction Valve complete
    Weight 1,900000 kg
    Weight 1,900000 kg
    Show full table Collapse table

    Applications & Tools

    CAD Model

    Cookies must be enabled to use this function. Please accept cookie privacy policy first.


    Downloads

    Description
    Filename
    Filesize
    Language / Country
    DTS Magnetventil, HT DS2400-Standard-DE-DE.pdf 125.4 kB DE / DE
    DTS 2/2-way Solenoid valve DS2400-Standard-EU-EN.pdf 125.1 kB EN / EU
    DTS Electrovanne HT DS2400-Standard-FR-FR.pdf 355.9 kB FR / FR
    DTS Solenoid, HT DS2400-Standard-US-EN.pdf 239.7 kB EN / US
    ABD EU-DoC|EU Declaration EG-EU-neu_1000282322-A_2400_EU-DoC_EMV_ATEX-EGBM_NSR_de-en-fr.pdf 2.4 MB EN,FR,DE
    MAN Zulassung EX 072x MA0721-ApprovalEX-DE-DE.pdf 525.3 kB DE / DE
    MAN Approval EX 072x MA0721-ApprovalEX-EU-ML.pdf 535.8 kB EN / EU
    MAN Certification EX 072x MA0721-ApprovalEX-FR-FR.pdf 540.5 kB DE / FR
    MAN Bedienungsanleitung MA2400-Standard-DE-DE.pdf 653.8 kB DE / DE
    MAN Operating Instructions MA2400-Standard-EU-ML.pdf 306.9 kB ,EN,FR,DE,IT,ES / EU
    Position
    Item No.
    Description
    01 236961
    03 14978
    04 14980