Bürkert - Close to you
Office /2
    • Main Office
      Burkert Middle East FZE
      Ras al Khaimah | United Arab Emirates

      Phone +971 7207 6696
      Fax +971 7207 6695
      E-Mail fnyrf.nr@ohexreg.pbz
    • Distributor
      Daly Fluid Technologies LLC – DFT
      Dubai | United Arab Emirates
      Phone +971 4887 8185
      Fax +971 4887 8184
      E-Mail fnyrf@qsgzr.pbz
  • Main Office
  • Headquarters
  • Systemhaus
  • Distributor
  • Office
  • Plant
  • Logistic center
bürkert
We make ideas flow.
We make ideas flow.

    Servo-assisted 2-way high-flow solenoid control valve

    Type 6223 / Ident No. 132202

    Produkt-Foto Typ 6223

    The depiction of the products may differ from the actual specific design.

    • Produkt-Foto Typ 6223
    • Produkt-Foto Typ 6223
    • Massbild
    • Massbild
    • Massbild

    2/2-way-solenoid control valve pilot op.

    • Control valve for continuous control of liquids
    • Low hysteresis and high repeatability
    • Control with PWM signal
    • Servo-assisted, tight closing valve

    For selecting the correct product please refer to the technical data, images and notes for proper use according to the data sheet.

    Product description

    The valve Type 6223 can be used for the control of larger flow quantities. Low hysteresis, high reproducibility and good response sensitivity guarantee good positioning behaviour. The valve closes tight. The push-over coil is easy to replace.


    Commodity Codes
    84818079
    Country
    DE

    Technical attributes

    Name
    Value
    Unit
    Type 6223
    Valve function A - normally inlet port 1 (P/NC) closed
    Fluidic port connection number 2 PCE
    Valve function number of switching positions 2 PCE
    Actuator type Plunger valve
    Operation servo-controlled
    Main valve operating principle Piston
    Switch function constant
    Main valve orifice 1 (P) (mm) 13 mm
    Main valve orifice 1 (inch) 1/2 inch
    Sealing toward outside material FKM (Fluor rubber)
    Seat seal material category Elastomer
    Seat seal material FKM (Fluor rubber)
    Main valve wetted material Brass
    Core guide Sliding ring
    Core guide 2 Sliding ring
    Vacuum version No
    Analysis version No
    Oxygen version No
    Steam version No
    Media separation No
    Flow Above seat
    Port connection 1 type Inner thread
    Port connection 1 thread type G
    Port connection 1 thread marking 1/2
    Port connection 2 type Inner thread
    Port connection 2 thread type G
    Port connection 2 thread marking 1/2
    Voltage / rated voltage 24 V
    Voltage / rated voltage 24 V
    AC voltage No
    DC voltage Yes
    Voltage tolerance positive 10 %
    Voltage tolerance negative 10 %
    Coil type placed on top
    Coil insulation material (encasement) PA (Polyamide)
    Coil size 40 mm
    Protection type (IP max. with suitable connector) 65
    Thermal insulation class of the actuator H
    Rated power consumption 10 W
    Electrical connection sort Plug pattern form A according to DIN EN 175301-803
    Electrical connection number of contacts 2 + Grounding conductor
    Electrical connection type male
    Cable plug in delivery not included
    Electrical connection position in direction of flow left
    Kv value (water) 2.7 m3/h
    QNn value (gas) 2695 l/min
    PWM frequency min. 180 Hz
    PWM frequency max. 280 Hz
    Operating range 1:10
    Nominal operation/Duty cycle 100 %
    Nominal pressure min 0.5 bar
    Nominal pressure max 10 bar
    Differential pressure max 10 bar
    Temperature medium min -10 °C
    Temperature medium max 90 °C
    Temperature environment min -10 °C
    Temperature environment max 55 °C
    Mounting position any
    Pilot control seal material FKM (Fluor rubber)
    Medium-contacting part core material Stainless steel
    Medium-contacting part stopper material Stainless steel
    Medium-contacting part core guide tube material Stainless steel
    Medium-contacting part core guide element 1 material PTFE (Polytetrafluorethylene)
    Medium-contacting part core guide element 2 material PTFE (Polytetrafluorethylene)
    Medium-contacting part spacer sleeve material Stainless steel
    Weight 0,561000 kg
    Weight 0,561000 kg
    Show full table Collapse table

    Applications & Tools

    CAD Model

    Cookies must be enabled to use this function. Please accept cookie privacy policy first.


    Downloads

    Description
    Filename
    Filesize
    Language / Country
    ABD EU-DoC|EU Declaration 1000253141-A_6223_EU-DoC.pdf 1.9 MB EN,FR,DE
    DTS Proportionalventil DS6223-Standard-DE-DE.pdf 719.1 kB DE / DE
    DTS Proportional Valve DS6223-Standard-EU-EN.pdf 711.5 kB EN / EU
    DTS Proportional Valve DS6223-Standard-US-EN.pdf 230.5 kB EN / US
    MAN Additional Information Ex MA6013-CodePX04-EU-ML.pdf 154.7 kB EN,FR,DE / EU
    MAN Additional Information Ex MA6013-CodePX11-13-EU-ML.pdf 201.7 kB EN,FR,DE / EU
    MAN Operating Instructions MA6223-Standard-EU-ML.pdf 229.5 kB EN,FR,DE,ES / EU
    MAN PWM-frequency prop.-valve MA8605-Supplement-EU-ML.pdf 163.2 kB EN,FR,DE / EU
    MAN ATEX - Approval MAAC10-ATEX2129X-EU-ML.pdf 1.3 MB EN,FR,DE / EU
    MAN Zulassung EX AC10 MAAC10-ApprovalEX-DE-DE.pdf 1.5 MB DE / DE
    MAN Approval EX AC10 MAAC10-ApprovalEX-EU-ML.pdf 1.5 MB EN / EU
    MAN Certification EX AC10 MAAC10-ApprovalEX-FR-FR.pdf 1.5 MB FR / FR
    Position
    Item No.
    Description
    8376 Plug connection 28 mm
    178354 Dig. control electroncis for prop.valves
    178355 Dig. control electroncis for prop.valves
    783573 Plug connection 28 mm